Isis-proteus-7-7 May 2026

Place pins on the edges of your 2D box. You can rotate them (using the keypad + or - ) so the connection point faces outward. : Double-click each pin to open the Edit Pin dialog.

: Click Next to link a PCB footprint (from ARES) if you plan to design a board later. Save to Library : isis-proteus-7-7

Use the to draw a box around your entire drawing (box and pins). Right-click the selection and choose Make Device . Configure Device Properties : Place pins on the edges of your 2D box

: For digital testing, you can use the Digital Pattern Generator instrument to "generate" signal patterns (pieces of data) for your simulation. Make a New or Custom Part in Proteus -Step by Step Guide : Click Next to link a PCB footprint

Click and drag on the schematic sheet to draw the shape of your component. : Select Component Pin Mode (the icon with a dot and a line).

: Give your component a unique name (e.g., "MY_CHIP_77").

: Use standard codes like U for ICs, R for resistors, or C for capacitors.